Have a question about our products or can't find what you're looking for ?
TF448 double sided bonding tape.
TF448 has been specially developed for the bonding of skirtings, cappings and cove formers used in the installation of commercial floor coverings.
- Strong initial tack and permanent bond
- Low toxicity
- No waste
- Speed up installations
Apply TF448 to the faces of the part(s) to be bonded. Remove the release liner and fix to the wall first and the press down firmly to create an instant bond.
Apply TF448 to the faces of the part(s) to be bonded. Remove the release liner and fix to the wall first and the press down firmly to create an instant bond.
Certificates
Technical data
| PROPERTY | RESULT |
| Composition | Tear resistant PES/PVA non-crimp fabric tape with 440 g/m² special coating |
| Open Time/Workability | Once release paper is removed apply immediately to substrates |
| (at +20°C) | |
| Thickness | 0.45 mm |
| Coverage | 50 m rolls |
| Application Temperature Range | +15° to +30°C |
| Service Temperature Range | -20°C to +70°C |
| Storage | Store in shaded dry conditions between +5°C and +30°C - DO NOT ALLOW TO FREEZE |
| Shelf Life | 24 months from manufacture date when stored as recommended in original unopened containers |
Description
TF448 is a tear resistant, very aggressive-grab double sided bonding tape.
Usage Guidelines
Apply TF448 to the faces of the part(s) to be bonded. Remove the release liner and fix to the wall first and the press down firmly to create an instant bond.
Preparation
- Site conditions must comply with British Standards CP 102, BS 8203, BS 5325 and supplementary specifications.
- The surfaces must be sound, clean, dry and free from oil, grease, paint, excessive dust and other contaminants liable to impair adhesion.
- Concrete and sand/cement screeds must be completely free from laitance.
- PVC should be conditioned in the environment in which it is being installed for a minimum of 24 hours.
Health + Safety Precautions
Safety data sheet must be read and understood before use.
Packaging
Widths: 25, 50 and 85 mm x 50 m long rolls
Cleaning
No cleaning required.
Guaranty / Warranty
tremco illbruck products are manufactured to rigid standards of quality. Any product which has been applied (a) in accordance with tremco illbruck written instructions and (b) in any application recommended by tremco illbruck, but which is proved to be defective, will be replaced free of charge.
No liability can be accepted for the information provided in this leaflet although it is published in good faith and believed to be correct.
tremco illbruck Limited reserves the right to alter product specifications without prior notice, in line with Company policy of continuous development and improvement.