Explore our brands

Have a question about our products or can't find what you're looking for ?

Contact Us
Back to product listing
CP150
MMA Concrete Primer

CP150 is a two component concrete primer, consisting of CP150 Resin and CP510 Initiator. CP500 Filler and CP508 Medium Fine Sand may be added when using as a high build primer.

CP150 is suitable for priming concrete, brick and masonry substrates prior to the application of the specified MMA rapid-cure coating system.

  • Fast curing concrete primer which cures in approximately 30 minutes
  • Can be applied at temperatures as low as -10°C
  • The MMA Coating System can be open to vehicular traffic within 2 hours
  • Quick and easy to apply

Surface Preparation

     

  • The surface must be smooth, dry, firm and free of dust, fat and oil and any other contaminants liable to prevent adhesion to the substrate.
  •  

  • The concrete must be mechanically prepared by shot blasting.
  •  

Application Instructions

     

  • CP150 Resin should be stirred well to achieve a homogeneous state. Once fully mixed, add CP510 Initiator and mix thoroughly again using the same method as above. When used as a high build primer coat CP500 Filler should then be added and mixed thoroughly into the resin using a slow speed drill and paddle. CP508 Medium Fine Sand should then be added and mixed thoroughly into the resin using a slow speed drill and paddle. Refer to the table below for dosage rates.
  •  

  • For application of CP150 as a primer coat use a short pile roller.
  •  

  • When applying as a high build coat pour the mixed material onto the floor in ribbons and spread using a notched rubber squeegee.
  •  

  • Apply CP508 Medium Fine Sand into the still wet primer at a rate of 1.5 kg/m² or as required.
  •  

  • For application details refer to tremco illbruck Technical Services.
  •  

For full application details, refer to product data sheet or contact tremco illbruck customer services on 01942 251400.

Technical data

PROPERTY
RESULT
CompositionCP150 is a two component methyl methacrylate-based concrete primer 
Viscosity
(DIN 53018 at +25°C)
100 - 130 mPa*s
Density
(ISO02811 at +25°C)
0.99 g/cm³
Pot Life/Application Window (at 20°C)Approximately 15 minutes
Curing Time
(at +20°C)
Approximately 30 minutes
Flash Point (ISO 1516)+11.5°C
Tensile Strength
(ISO527)
10.3 N/mm²
Elongation at Break0.62%
E Modulus1990 N/mm²
Density
(ISO 1183 at +20°C)
1.16 g/cm³
Application TemperatureCP150 can be applied at substrate and ambient temperatures as low as -10°C, providing that the substrate is frost free
CoverageApplication rates may vary depending on substrate conditions
StorageStore in dry, shaded conditions between +15°C and +20°C
Shelf Life6 months when stored as recommended in original unopened containers
Downloads

Product Finder

Application Area
Products
Systems